M5 Flanged Button Screws - Replacement Parts

FMS Accessories offers the bushing and bolt kit needed to mount various accessories to the handlebars on the K52 / 2015 - 2022 R 1200 / 1250 RT-P including radar remote controllers, microphone mounts, cell phone holders, etc. The kit includes a special aluminum bushing, stainless steel washer and pan-head stainless steel Torx head bolt. The kit is available in standard length as well as +5 mm and +10 mm longer bolts for use when multiple brackets are attached to one side. The M10 Torx head bolt already has encapsulated thread locker on the bolt end - the Torx head enables you to apply the required 40 Nm of torque as specified by BMW without deformation. Formerly BMW PN 71 60 2 452 841

A notepad holder / bail is a very handy accessory for holding notes, directions or other documents either when parked or while riding. Constructed of formed and tumbled stainless steel, with a stainless steel clip bail riveted to the base. Includes, aluminum spacers, longer stainless steel bolts and 50 sheet notepad. Replacement notepads are available separately in Replacement Parts. Formerly BMW PN 71 60 2 452 888

The BMW Navigator mount was designed to enable mounting the traditional BMW Navigator GPS using a BMW Four Button cradle or a BMW Locking cradle (cradles & locks sold separately through BMW) onto the 2021 and later R 1250 RT-P models with TFT display. Also works with Garmin Zumo (select the 4-button cradle for this application). Not compatible with SAT radio antenna - if desired on unit with SAT radio antenna, antenna will need to be relocated* from the dashboard to the rear of the motorcycle for best reception. A new RFI shield has been developed to block much of the RF interference from the TFT display that was affecting the accuracy of the GPS signal (order separately below). Note: It has been reported that the Touratech GPS locking mounting cradle is heavier than the BMW cradles and may cause "bouncing" of the display.

Replacement Lidar gun holster mounts. Sold separately for use as a replacement part, or to change the mount when you upgrade to a different model motorcycle. All mounts have the 5-hole pattern used on FMS Accessory Lidar gun holsters, Zebra boxes, etc. Note that tight fitting brackets are used on narrow holsters to keep the gap between the holster and fairing from being too large. Not recommended for used with wider holsters.