Replacement Lidar Gun Lock

Left rear large flashlight / PR-24 baton holder on 2015+ RT-P models. Constructed of powder coated aluminum frame and tubes. Baton tube has an obstruction at the bottom for safety to block a baton from dropping through. Compatible with rear radar antenna mounts. Ships complete with mounting hardware.

Vintage Whelen PAR36ES Strobe Light. Whelen Model REP36ESR. New In Box / Old Stock / No Warranty From FMS. Old BMW PN: 63 17 1 469 348

Special relay harness designed to disable power to your LIND laptop charger when the motorcycle ignition is OFF. Enables charging the laptop battery when motorcycle is running, but shuts-off 50 seconds after ignition OFF via SPST relay. Due to varied locations for LIND chargers, unit comes with long wire leads and an adhesive cable tie base to mount relay where most convenient. Note that without this relay harness, each and every time the motor is turned-OFF, the LIND charger will remain ON for 30 minutes, draining the auxiliary battery. Reducing parasitic load extends the life of the auxiliary battery! R 1300 RT-P has a new circuit replacing this harness - order FMSA-EL-LCP.

The rifle mount requires a mounting bracket. New R 1300 RT-P bracket for all barrel lengths now listed - RH side only! Though right side is normally the preferred side as it is the dismount side, a left side bracket is also available for specific models. Standard RH or LH brackets accommodate barrel lengths up to 14". The RH Long Rifle Mounting bracket accommodates barrel lengths up to 18" (note length includes barrel + suppressor if equipped). Note that using the Long Rifle Mounting bracket raises the rifle stock above the radio box lid height and may partially obstruct the RH side rear pod emergency light, depending upon view angle. Note when using RH long rifle mount w/long barrels, we suggest ordering the heat shield to protect the muzzle cup from excessive exhaust heat. LASO Bracket is a RH bracket, elevated similar to the RH Long, but for SBR rifles where no additional mount is required for the lower support. Use together with lower support / Std. muzzle cup w/heat shield. The Long rifle cable cover kit is recommended when using the RH Long Rifle Mount.