Tomar Strobecom II Mounting Bracket

BMW 2.5 mm high current plug to connect radios and other devices to the radio power plug on your BMW motor. BMW plug Code A (black housing) supplied with two sockets for 14 - 18 AWG wire connections (w/conductor & insulation crimps). Formerly BMW PN 71 60 2 452 887

Split the BMW 2.5 mm high current radio power connection (code A) on your BMW motors into two plugs when you need to use this power source to operate more than one item. Harness is made from high quality components with professional terminal crimps and PVC insulation over wires. BMW 2.5 mm Code A socket and pin housings (black) or Code B pin and socket housings (white). Code B is used to split the lighter socket power feed. Overall length: 5.5 inches Wire size: 16 AWG. New version with dual ATM fuse holders for faster installation of radios individually fused receiver and control head. Code A formerly BMW PN 71 60 2 452 880 Connector: BMW 2.5 mm Radio Power Connection Plug Code A. Note: Order two (2) mating Radio Power Connection Plugs with each Radio Power Plug Divider

Special relay harness designed to disable power to your LIND laptop charger when the motorcycle ignition is OFF. Enables charging the laptop battery when motorcycle is running, but shuts-off 50 seconds after ignition OFF via SPST relay. Due to varied locations for LIND chargers, unit comes with long wire leads and an adhesive cable tie base to mount relay where most convenient. Note that without this relay harness, each and every time the motor is turned-OFF, the LIND charger will remain ON for 30 minutes, draining the auxiliary battery. Reducing parasitic load extends the life of the auxiliary battery!

FMS Accessories is pleased to offer a Lidar gun holster adapter plate for use on all MY 2015 and later R 1200 / 1250 RT-P models. This plate can be used to adapt earlier 4-bolt Lidar & radar gun holsters from MY 2014 & earlier models to the current K52 generation. The plate is constructed of 12 GA stainless steel, tumble-finished, complete with stainless steel hardware and can be fitted on either the right or left side protection bar. Not required for any FMS Accessories Lidar gun holster! Plate comes with washer-head Torx bolts for top mounting position as well as a counter-sunk Torx bolt when flush installation is required. To use countersunk bolt, you will need to countersink the upper bolt location depending upon which side of the motorcycle you are installing the plate. Original Plate MY2015-2018 Formerly BMW PN 71 60 2 409 956 Tight Fitting Plate MY2019+ Formerly BMW PN 71 60 2 452 407 797