BMW Navigator Mount - 2021+ TFT

$57.00

The BMW Navigator mount was designed to enable mounting the traditional BMW Navigator GPS using a BMW Four Button cradle or a BMW Locking cradle (cradles & locks sold separately through BMW) onto the 2021 and later R 1250 RT-P models with TFT display. Also works with Garmin Zumo (select the 4-button cradle for this application). Not compatible with SAT radio antenna - if desired on unit with SAT radio antenna, antenna will need to be relocated* from the dashboard to the rear of the motorcycle for best reception. A new RFI shield has been developed to block much of the RF interference from the TFT display that was affecting the accuracy of the GPS signal (order separately below). Note: It has been reported that the Touratech GPS locking mounting cradle is heavier than the BMW cradles and may cause "bouncing" of the display.

Availability: In stock

SKU: FMSA-MT-GPS

Version *
RFI Shield	RFI Shield for BMW NAV Mount [+$45.00]
Blank Body Plugs	Body Plugs for 6mm Holes (Set of 4) [+$1.50]

Qty:

Installation Guide

Add To Estimate

BMW GPS Four Button Cradle or Locking Cradle / Lock Cylinder Kit Not Included! Purchase Separately from your Authorized BMW Dealer.

Set of four (4) 6mm body plugs is available to fill holes from mounting the GPS bracket.

Click on Installation Guide for more mounting information.

*Customers state purchasing an XM radio antenna from Amazon / connecting to radio under passenger seat. Leave original cable in place. Mount replacement antenna on rear TS housing.

If you are adapting a non-BMW cradle to this mount, you may also need the 3 conductor pin housing to fit the BMW NAV connection behind the dashboard. See below in Related Products for Sealed BMW Electrical Connector Sets, then select the 3-position pin housing Code B from the drop-down list.

Free shipping is limited to the continental United States.

Shipping charges apply to international shipments.

Customers who bought this item also bought

Radio Power Connection Plug Code A

FMSA-EL-RPP

BMW 2.5 mm high current plug to connect radios and other devices to the radio power plug on your BMW motor. BMW plug Code A (black housing) supplied with two sockets for 14 - 18 AWG wire connections (w/conductor & insulation crimps). Formerly BMW PN 71 60 2 452 887

$10.00

Accessory I-III Connection Plugs

FMSA-EL-ACP

Accessory connection plugs are used to connect accessories to the two-conductor plugs on the radio box terminal strip in positions 8, 9 and 10, referred in the BMW instructions as Accessory I, II or III. Three (3) two conductor socket housings along with six sockets are provided with each PN quantity selected. Formerly BMW PN 71 60 2 452 846

$9.50

Rifle / Shotgun Mounting Bracket

The rifle mount requires a mounting bracket. Theses brackets are available for right or left side mounting. Though right side is normally the preferred side as it is the dismount side, a left side bracket is also available. Standard RH or LH brackets accommodate barrel lengths up to 14". The RH Long Rifle Mounting bracket accommodates barrel lengths up to 18" (note length includes barrel + suppressor if equipped). Note that using the Long Rifle Mounting bracket raises the rifle stock above the radio box lid height and may partially obstruct the RH side rear pod emergency light, depending upon view angle. Note when using RH long rifle mount w/long barrels, we suggest ordering the heat shield to protect the muzzle cup from excessive exhaust heat. LASO Bracket is a RH bracket, elevated similar to the RH Long, but for SBR rifles where no additional mount is required for the lower support. Use together with lower support / Std. muzzle cup w/heat shield. Formerly BMW PN 71 60 2 452 840 RH

$59.00

Fairing Waterproof Lighter Socket

FMSA-EA-LSF

Lighter outlets are commonly installed on motor fairings to assist officers with powering various devices (also see USB outlet w/voltmeter and ON-OFF switch). Located on the RH side of the fairing above the BMW power socket, the lighter socket shares the connection to the BMW/Hirschmann connectors for the accessory power socket via a special "Y" harness. It is not recommended to use USB adapters with the lighter socket unless they are removed after use (they sometimes confuse the circuit which does not shut-down properly after ignition-OFF). Also make sure to remove any adapters prior to utilizing the BMW battery charger for the same reason. Formerly BMW PN 71 60 2 407 785

$45.00

FMS Accessories

BMW Navigator Mount - 2021+ TFT

Are you sure to place the backorder?

Customers who bought this item also bought

Radio Power Connection Plug Code A

Accessory I-III Connection Plugs

Rifle / Shotgun Mounting Bracket

Fairing Waterproof Lighter Socket

Related products

Sealed BMW Electrical Connector Sets