Sealed BMW Electrical Connector Sets

The BMW Navigator mount was designed to enable mounting the traditional BMW Navigator GPS using a BMW Four Button cradle or a BMW Locking cradle (cradles & locks sold separately through BMW) onto the 2021 and later R 1250 RT-P models with TFT display. Also works with Garmin Zumo (select the 4-button cradle for this application). Not compatible with SAT radio antenna - if desired on unit with SAT radio antenna, antenna will need to be relocated* from the dashboard to the rear of the motorcycle for best reception. A new RFI shield has been developed to block much of the RF interference from the TFT display that was affecting the accuracy of the GPS signal (order separately below). Note: It has been reported that the Touratech GPS locking mounting cradle is heavier than the BMW cradles and may cause "bouncing" of the display.

USB sockets are becoming more commonly installed on motor fairings to assist officers with charging cell phones, helmet headsets, etc. However, many of the available sockets when connected to the fairing power socket confuse the BMW 2.5Ah battery charger by creating a small parasitic load. FMS has sourced a New quick-charge 3.0 technology USB socket (type A and C) with an On-Off switch, enabling the officer to turn-off the socket when not in use, therefore not creating issues during battery charging (particularly off-season storage when connected to the fairing power socket outlet). Additionally, the USB has a digital voltmeter, enabling the rider to see the state-of-charge of the battery that the voltmeter is connected to (based on the connection type selected). The voltmeter is also visible through the waterproof cover. When connected to the auxiliary battery power source, the voltmeter provides an excellent indication of your auxiliary battery state-of-charge as well as when the motorcycle is charging the aux. battery. Formerly BMW PN 71 60 2 446 871

FMS Accessories offers the bushing and bolt kit needed to mount various accessories to the handlebars on the K52 / 2015 - 2022 R 1200 / 1250 RT-P including radar remote controllers, microphone mounts, cell phone holders, etc. The kit includes a special aluminum bushing, stainless steel washer and pan-head stainless steel Torx head bolt. The kit is available in standard length as well as +5 mm and +10 mm longer bolts for use when multiple brackets are attached to one side. The M10 Torx head bolt already has encapsulated thread locker on the bolt end - the Torx head enables you to apply the required 40 Nm of torque as specified by BMW without deformation. Formerly BMW PN 71 60 2 452 841

FMS Accessories offers the bracket needed to mount the radio microphone or other accessories to the handlebars on the 2015 - 2022 R 1200 / 1250 RT-P models. A new version is also available that is 1.5" taller / forward off-set to work with radio heads that are mounted higher, where the microphone key could otherwise ride against the radio head. As used by AZ DPS. Note: Requires the special bolt kit listed in related products. Formerly BMW PN: 71 60 2 452 875